Stone Slabs

Stone slabs from CHUXIN give architects, interior designers, fit-out contractors and custom furniture makers one material that can carry a scheme across floors, walls and work surfaces. The range covers quarried natural stone as well as engineered composites, so a project can use the unrepeatable veining of a real block in one area and the consistent tone of a manufactured slab in another. Every slab is supplied cut to size and edge-profiled, with the surface finished to match your drawings. Typical buyers are hospitality and office fit-out teams, joinery workshops, stone fabricators and design studios specifying feature surfaces.

Stone Types & Surface Character

• Marble stone slabs — quarried stone whose veining runs through the block; a polished finish brings the pattern up sharp, while honing softens it for walls where glare is a problem.
• Travertine stone slabs — a warmer, more softly banded stone that usually reads well honed or brushed rather than highly polished.
• Granite — a fine crystalline grain and a dense face that suits flooring and counters in busy areas.
• Limestone and terrazzo — limestone for flat, muted colour; terrazzo for a speckled aggregate pattern over a uniform base.
• Colour range — white, beige, grey and black in veined or speckled faces, so a scheme can run from quiet and even to strongly patterned.
• Finish and surface character — the sample set spans a light grey speckled face under a matte finish and a medium grey veined face under a polished finish; anti-slip surfaces go on floors and wet zones, polished faces on feature walls and counters.

Natural & Engineered Stone Options

Natural stone and engineered composite behave differently on site. Natural stone slabs are cut from quarried blocks, so each piece carries its own veining, movement and slight colour shift — useful when you want a surface that cannot be repeated anywhere else in the building. Engineered composites bind stone aggregate into a consistent slab, which gives the same tone and pattern across a long run: helpful for repeated hotel bathrooms, long countertops and phased installations where later pieces must match earlier ones. Both are fabricated the same way and both accept CNC cutting and edge profiling. Tell us which areas need matched tone and which should stay one-off pieces, and we will plan the slab layout around that.

Fabrication & Installation

1. Check slab sizes, layout and joint positions against your site drawings before any cutting starts.
2. Dry-lay the pieces on site first to review veining direction, tone changes and how the joints line up across the run.
3. Set floors and walls on a wet-fix bed, or fix mechanically to a prepared substrate for dry-lay systems.
4. Keep joints tight and even, and allow movement at perimeter edges and around structural openings.
5. Finish edges on site where cut-outs for sockets, basins or drains interrupt the profile.
6. Protect the installed faces through the rest of the fit-out so the handover is clean.

Scale & Supply Capability

CHUXIN supplies decorative surface materials direct from our factory, and our range covers aluminium, brass, copper and stainless steel sheets, general metal sheet, fabric-covered panels, glass and mirror materials, leather-finish surfaces, stone slabs, and wallpaper and wallcoverings. That breadth lets you source metal, stone, glass, panel and wall finishes for a single commercial interior or facade project from one supplier. We support custom sizing and fully customizable OEM production with flexible finishes, so specifications can be matched to your drawings, sample requirements and project schedule.

FAQ